KASTOR SAGA-20PK KSIL, Installation And Usage Manual, Page: 39 / 75

39 / 75
2.3.2. Installation on tiled and waterproof floor
We do not recommend installing the stove directly a tiled floor, as its moisture sealing, the glute
ect. may contain components that are not heat resistant.
The Kastor protective stove base is sufficient, a separate fronting plate is not necessary.
2.4. Safety distances and protections
2.4.1. Safety distances (picture 5)
If the flue pipe starts of from the top of the stove with a no insulated connection pipe, the safety
distance is 400mm side directions and 400mm horizontal surface upward
Take into account the safety distance of stove.
See picture 5.
The stove's safety distance to flammable material is 250mm to the side, at the back 250mm from
the stove’s outer surfaces. A safety distance of 1000mm should be left for in front of the stove
due to heat radiation and to allow room for work and maintenance. The absolute minimum is
500mm, but then you must ensure that the nearest panel in front of the stove does not exceed a
temperature of 85
o
C during test heating.
Safety distance upwards, (table 1) measured from stone surface. A protective plate with a 30mm
air slot must be placed on the ceiling if the measurements are not sufficient.
If the sauna has a flammable floor in front of the stove, the area to be protected extends 100mm
beyond the door’s sides and a minimum of 400 mm in front of it. In this case, the protection must
be at least a 1 mm thick metal sheet.
If the stove is installed with one side and the back against a brick wall, safety distances of 50 mm
to the side and 50 mm at the back are sufficient. If it stands with its back and both sides next to
brick wall, 100mm should be left on both sides to ensure air circulation. At the back, 50mm
remains sufficient.
The pipe`s insulated part within the sauna must always extend to 400mm below the ceiling.
For chimneys, the minimum safety distances to flammable material differs from product to
product. Always check the manufacturer’s instructions. In case of doubt, approach your local fire
safety officials.
2.5. Connecting the stove to a brick chimney
The stove can be connected to a brick chimney from the top and from behind. For a brick
chimney connection, the safety distances and protectors named in chapter 2.4. and the
chimney’s masonry regulations must be adhered to.
JK/KSIL
– models can onley be connected from the top
2.5.1 Stoves Saga JK and KSIL with extended feed doors (picture 6)
Stoves with extended feed doors must only be installed into walls made of non-flammable
material (brick, concrete etc.).
In this case, non-combustible material must be the width of the
heater width dimension. (picture 6).
The height of the
sauna cabin altitude. If there is a flammable floor in the room with the door, the
area requiring protection must extend 100mm beyond both sides of the door and at least 400mm