LEDC11 MANUAL
7
For J/VFX units:
Included with the light kit is optional hardware for use instead of the snap-on light clip. Assemble parts K, L,
M, and N as shown in the diagram below and tighten until secure. 7/16’’ socket and wrench required.
For 1/2, 3/4, & 1HP AF units:
Use alternate hardware instead of the snap-on light clip, following the directions above and continuing to
step 6 on page 6.
For Large Surface Aerator units:
Supplementary hardware is required in order to mount RGBC5 light fixtures to a large (2HP+) surface aera
-
tor. Use the additional hardware kit (P/N
840303
for 3 light fixtures or
840306
for 6 light fixtures).
These kits are sold separately. Contact Kasco at [email protected] or your local distributor for order
information.
ALTERNATE MOUNTING INSTRUCTIONS
K
L
M
N
Back to Contents