LEDC11 MANUAL
2
SAFETY FIRST
Please read and follow these important instructions to help ensure your safety and the quality performance
of your Kasco equipment.
•
LEDC11 kit is 120Vac and MUST be plugged into a GFCI protected receptacle or GFCI protected field
terminal connections.
•
LEDC11 fixtures MUST be properly submerged (approximately halfway) to avoid overheating; insufficient
submersion or operation out of water will damage fixtures and void warranty.
• Use caution when dealing with any electrical and/or moving equipment.
• Under NO CIRCUMSTANCES should anyone enter the water with the electrical equipment plugged in
and/or in operation.
• Kasco WaterGlow lighting kits are intended for use with a Listed control panel having a GFCI protected
receptacle, or field wiring terminals and disconnect switch, or a timer with a disconnect for use with a
GFCI receptacle. They are intended to be mounted on a floating fountain or aerator for use in a natural
or man-made body of water to comply with NEC Article 682.
• Kasco WaterGlow lighting kits have not been evaluated for use in swimming pools, spas or stationary
fountains.
•
Use extreme caution around water, especially cold water, as in spring, fall, and winter, which poses a
hazard in and of itself.
• NEVER lift or drag the equipment by the power cords. If you need to pull the unit to the side of the pond,
use the anchoring ropes.
• Do not use boats that tip easily for lighting kit installation and follow all boating safety rules and regu-
lations, including wearing a PFD (Personal Flotation Device). Do not use waders in deep ponds/lakes or
ponds/lakes with drop-offs, drastic slopes, or soft bottom material.
• For more information regarding your control panel instructions, refer to your equipment owner’s manu-
al. A control panel must be installed a minimum of 5 feet (3m in Canada) from the body of water unless
separated from the body of water by a fence, wall, or other permanent barrier that will make the unit
Back to Contents