RM-150 FLOOR MOUNT MANUAL
7
BASE ASSEMBLY
1.
Assemble the three mixer base legs loosely to each other using six 5/16” flanged screws (B) and 5/16”
nylon locknuts (C).
2. Place the mixing unit upside down on the foam packing from the mixer unit box, if available.
3. Slide the loosely assembled mixer base ring over the inverted mixer unit.
4.
Make sure the leg with the clamp ring (M) affixed is in line with the clamp on the mixer cage.
5. Position the mixer base ring approximately 3 inches from the mixer unit cage.
Tighten the six 5/16”
screws (B) to nuts (C) in order to secure base assembly to the mixer.
6.
Clip all three of the 5 link chains (S) to the bottom cage using the snap hooks (R). This will ensure the
cotter pins (Q) do not get lost.
5
B
C
1
3 inches
3
Maintain
alignment
Cage clamp
M
4
M
2
6
S
R
Q
Back to Contents