Instructions for use SOM 62/32/22 LED
9 SOM 62/32/22 LED EN 2017-03
7.1.2
Installation of swivel arm, suspension arm and microscope
Carry out the following installation steps as in Figure 2:
Undo the lock screw (3) on the upright guide cylinder (1) of the column (2)
Put on the swivel arm (5). Ensure in the process that the star knob (4) is undone.
Screw the lock screw (3) back on
Undo the safety cap (6) from the guide cylinder (7) of the microscope carrier (8)
Press in the lock pin (10) and push in all the way the guide cylinder of the microscope carrier.
The star knob (9) must be undone for this. Release the lock pin - it engages into place and
prevents the microscope head (11) from falling out.
Hand-tighten the lock cap (6) onto the projecting threaded part of the guide cylinder
CAUTION
Always ensure that the lock screw (3) for securing the swivel arm, and
the lock screw (6) for securing the microscope head, are mounted
correctly.
Figure 2
