English
71
Observe the respective safety regulations when cleaning
the vehicle with a high-pressure cleaner.
Do not use aggressive detergents.
Wash the vehicle only when the engine is switched off to
protect the air filter.
1. To avoid the risk of fire: Check the vehicle for oil and fuel
leakage. Have leaks repaired by Customer Service.
2. To avoid the risk of fire: Clean the engine, muffler and
battery of plant residues and oil.
3. If necessary, clean the engine with a brush, compressed
air or with low water pressure if necessary.
4. Clean the mudguards/wheel arches.
10.8.2Clean the radiator
ATTENTION
Risk of injury from sharp edges
Use protective gloves for cleaning.
1
Lock
2
Right side panel
3
Air-conditioner condenser
4
Combination cooler
–
Charge air, water and hydraulic oil cooler
1. Release the side panel lock with a square wrench.
2. Tilt the panel outwards, a safety rope holds it in position.
3. Manually remove coarse dirt from the radiator.
4. Use a soft brush or broom to clean with compressed air
(5 bar max.) or low water pressure.
10.9 Fuses
10.9.1Fuses in the cab
The fuses in the driver's cab are located behind a cover on
the middle rear wall of the cab.
1
Cover
2
Locks
3
Fuses
4
Diagnostic connector
1. Fold the passenger seat backrest forward.
2. Open the cover latches then tilt the cover and remove it
upwards.
3. Replace defective fuses.
Note
Use only fuses with the same ampere rating.
10.9.2Fuses on the vehicle
The next fuses are located on the vehicle behind a cover
on the right side panel.
1
Right side panel
2
Cover
3
Fuses
1. Release the side panel lock with a square wrench.
2. Tilt the panel outwards, a safety rope holds it in position.
3. Open the cover latch and remove the cover.
4. Replace defective fuses.
Summary of Contents for MC 250
Page 2: ......
