background image

10 

English

CAUTION

Dry running of more than 2 minutes leads to damage of 
the high-pressure pump. If the appliance does not build 
up pressure within 2 minutes, switch the appliance off 
and proceed in accordance with the instructions in 
Chapter "Troubleshooting".

CAUTION

Keep a distance of at least 30 cm when using the jet for 
cleaning painted surfaces to avoid damage.

ATTENTION

Car tyres, paint or sensitive surfaces such as wood 
should not be cleaned with the dirt blaster, as there is a 
risk of damage.

Illustration 

The pressure indicator on the trigger gun shows the cur-
rently set pressure level during operation with a Full 
Control spray lance.

Note:

 The pressure indicator is not significant during 

operation with the T-Racer and other accessories.

ATTENTION

The sensitivity of the materials can strongly differ de-
pending on the age and the condition. The so-called 
recommendations are non-binding.

Note:

 Detergent can only be added when the device is 

operated in low pressure mode.

Illustration 

Optional

Illustration 

Spray the detergent sparingly on the dry surface 
and allow it to react, but not to dry.

Spray off loosened dirt with the high pressure jet.

After operation with detergent: Run the machine for 
approximately 1 minute for a clear rinse.

ATTENTION

Risk of damage to the paintwork
When working with the washing brush, it must be free of 
dirt or other particles.

Note

: If required, the washing brushes can be used to 

work with detergent.

Illustration 
Release the lever of the trigger gun and lock it.

During longer breaks (more than 5 minutes), also 
turn the appliance off using the "0/OFF" switch.

CAUTION

Only separate the high-pressure hose from the trigger 
gun or the device when there is no pressure in the sys-
tem.

Release the lever of the trigger gun.

Turn off the appliance "0/OFF".

Disconnect the mains plug from the socket.

Turn off tap.

Press the lever on the trigger gun to release any 
remaining pressure in the system.

Lock the lever of the trigger gun.

Detach the appliance from the water supply.

Operation

High pressure operation

Full Control System

Pressure level

For example, recommended for 

HARD

Stone terraces made of paving 
stones or exposed aggregate con-
crete, asphalt, metal surfaces, gar-
den utensils (wheelbarrow, spade, 
etc.)

MEDIUM

Motorcar / motorcycle, brick sur-
faces, plastered walls, plastic furni-
ture

SOFT

Wooden surfaces, bicycles, sand 
stone surfaces, rattan furniture

MIX

Operation with detergent

Operation with detergent

Recommended cleaning method

After operation with detergent

Operation with washing brush

Interrupting operation

Finish operation

Summary of Contents for K 3 Premium Power Control

















Reviews: