Kärcher IVR-L 200/24-2 Tc Dp, Manual

Page: 14 / 184

14 English
Device with tilting chassis (Tc)
ATTENTION
Risk of injury
Risk of crushing due to the liquid container
tipping
Allow the lock to latch after tipping.
Behaviour in the event of an
emergency

DANGER
Risk of injury and material damage
when vacuuming inflammable materi-
als, or in the case of a short-circuit or
other electrical faults
Danger of inhalation of gases hazardous to
health, danger of electric shock, danger of
burns.
In the event of an emergency, switch off the
device and unplug the mains plug.
Electrical connection
The device may only be connected to an
electrical connection which has been set up
by a qualified electrician as per IEC 60364.
For the connection values see Technical
data and
type plate . Use of an extension
cable is prohibited.

DANGER
Danger of electric shock
Danger of death
Avoid damaging the power cables by driv-
ing over them or otherwise crushing them,
or by jerking them.
Protect the cables from heat, oil and sharp
edges.
Check the mains connection of the device
for damage every time before operation.
Do not operate the device using a damaged
cable. Have any damaged cables replaced
by a qualified electrician.
Symbols on the device
Marking the maximum permissible fluid
level
See chapter Checking the filling level dis-
play.
ATTENTION
Risk of damage to the device
Leaking water due to the maximum fluid
level being exceeded.
Drain the device before the maximum fluid
level is reached.
Device description
See graphics page for illustrations
Illustration A
1
Accessory holder
2
Unlocking lever
3
Tilting chassis
4
Liquid container
5
Preliminary filter cover
6
Preliminary filter cover lock
7
Suction hose connection
8
Filter
9
Drum pump on/off switch
10
Drum pump flow rate adjustment (+/-
button)
11
Suction head
12
Plugs
13
Power switch
14
Suction head lock
15
Mains cable
16
Screw plug
17
Deflector plate
18
Drum pump
19
Push handle
20
Disposal hose holder
21
Drum pump disposal hose
22
Stand pipe for drum pump
23
Steering rollers with parking brake
24
Maximum filling level mark
25
Drain hose
26
Ballcock
Start-up
See graphics page for illustrations
1. Bring the device into the working posi-
tion.
2. If necessary, secure the device using the
parking brake.
3. Ensure that the suction head is fitted
correctly.
4. Insert the suction hose into the suction
hose connection.
Illustration B