English
17
6. Close the water inlet.
7. Disconnect the water supply hose from the device.
8. Close the waste water drain hose and press it into the
holder.
Empty the coarse dirt container
1. Lift the coarse dirt container and pull it out.
2. Empty the coarse dirt container.
3. Reinstall the coarse dirt container.
Draining fresh water
1. Open the fresh water tank cap.
2. Drain the fresh water.
3. Clean the filter.
4. Fit the fresh water tank cap.
Shutting down the device
1. Turn the program switch to "OFF".
2. Remove the Intelligent Key.
3. Secure the device against rolling away.
4. Open the lid of the waste water tank and secure it with
the support so that the waste water tank can dry out. To
do this, swing the support down and position the lower
end at the desired level when swinging down the cover.
1
Waste water tank cap
2
Support
3
Level
5. Charge the batteries if necessary.
Gray intelligent key
The gray Intelligent Key grants the supervisory staff ex-
tended authorizations and setting options.
1. Insert the Intelligent Key.
2. Select the desired function by turning the info button.
Transport journey
1. Set the program switch to "Drive".
2. Press the Info button.
The following functions can be executed in the Transport
trip menu:
●
Set maximum working speed
●
Show operating hours counter
●
Clearing the maintenance counter
●
Show software versions
●
Adjust the R or D cleaning head
●
Switch speed-dependent water dosage on / off
●
Setting after-running times
●
Setting the language
●
Key management
●
Switch attachment kits on / off
●
Activate factory setting
Working speed
The working speed can be limited in the "Tempo" menu.
1. Turn the info button until "Tempo" is shown on the dis-
play.
2. Press the Info button.
3. Turn the info button until the desired maximum speed is
displayed.
4. Press the Info button.
Resetting the maintenance counter
If maintenance work shown in the display has been carried
out, the corresponding maintenance counter must then be
reset.
1. Turn the Info button until "Maintenance counter" is dis-
played.
2. Press the Info button.
The counter readings are displayed.
3. Turn the info button until the counter to be cleared is
highlighted.
4. Press the Info button.
5. Select "YES" by turning the Info button.
6. Press the Info button.
The counter is cleared.
Adjusting the cleaning head
1. Turn the info button until "Brush head" is displayed in the
menu.
2. Press the Info button.
3. Turn the info button until the type of the built-in cleaning
head is highlighted.
"Roll" = R cleaning head
"Disc" = D cleaning head
4. Press the Info button.
Speed-dependent water dosing
If the speed-dependent water dosing is switched on, the
brush irrigation changes proportionally with the speed.
The water dosing is also influenced by the setting of the re-
spective cleaning program (0 ... 100%).
Adjust speed-dependent or constant water dosing:
1. Turn the info button until "Water dosage" is shown on
the display.
2. Press the Info button.
3. Turn the info button until the desired function is high-
lighted.
4. Press the Info button.
After-running time
1. Turn the info button until the menu item "After-running
times" is shown on the display.
2. Press the Info button.
Setting
ON [ml/m
2
]
OFF[l/min]
0%
0
0
10%
7.5
0.675
20%
15
1.35
30%
22.5
2.025
40%
30
2.7
50%
37.5
3.375
60%
45
4.05
70%
52.5
4.725
80%
60
5.4
90%
67.5
6.075
100%
75
6.75