7m
4m
3m
8m
Side View
Infrared
Diagram of IR detecting area
0
3
3
4
4
0
1
+
3 2
MODE
H
L
D
E
1 SAVING
2 NORMAL
3 TEST
O
M
ON
OFF
U1
K1
E1
CZ1
ANT1
J1
J2
LED1
TEST
J3
Sensitivity Jumper
Working Mode Jumper
PIR Sensor
LED Switch
Temper Switch
L: Detecting Dia.:6m
H: Detecting Dia.:8m
Wireless Ceiling PIR Detector
Users' Manual
Wireless Ceilling PIR detector adopts advanced sensor and special IR processing chip. It works by detecting
spectrum of human body infrared. When human activate within the detecting area, the microprocessor will
alarm after comparing and operating the received signals. The temperature compensation could solve the
problem caused by environment temperature change and increase the detecting ability. Ceiling-mounted
installation is hiding and beautiful. It is widely installed for the halls, aisles, etc.
Detective Distance: dia. 6~8m
1.Main functions and features
2. Technical parameter
Ȩ
Ȩ
Ȩ
Ȩ
Ȩ
Ȩ
Ȩ
Ȩ
Ȩ
Ȩ
Ȩ
Ȩ
Ȩ
Ȩ
Ȩ
Ȩ
Ȩ
Ȩ
Automatic temperature compensation
Anti-white light interference
Anti-EMI
Pet immunity
Low power test and report
Two levels of PIR sensitivity optional
Easy installation; elegant shape
Detecting Angle: 360°
Standby Current: 45uA
Frequency: 433.92MHz
Transmitted Power:
40mW
Working Temperature: -10
~+50
Installation Way: ceiling mounted
Installation Height: 3~5m
Sensor
: dual pyroelectric IR sensor
Wireless Remit Distance: 400m (in open area)
Working Power: ER14250H 3.6V lithium battery
＞
℃
℃
3. Diagram of IR detecting area
4. Instruction of spare
type
Wor king Modes
Saving mode
Standard mode
Test mode
If people enter the detecting area and keep moving continuously,the
infrared detector will sends only one signal for first trigger only. The
infrared detector won't send new signal until new trigger after 10
seconds.
It is for testing the IR detecting scope. As long as a human body moves
in the detecting area, the indicator will be on without sending out signal.
very trigger, the PIR will block for 10 seconds and then send out
the signal.
After e
3 2 1
3 2 1
3 2 1
Remark:
1
2
4
.5
m
m
LED indicator
Alignment mark
on upper cover
(a small protuberance)
Snap-fits
Alignment mark on lower
cover (a longer groove)
If put the jumper in “ON” position, the LED indicator will work as following:
A. The LED indicator flashes once a second means the detector enters in blank situation.
B. The LED indicator is on for 3 seconds means the detector is sending wireless signal.
C. The LED indicator flashes once every five seconds means the battery power is lower
If put the jumper in “OFF” position,the LED indicator will stop working.
When it installed as the above,
the detecting area should be
as the diagram on the left.
