Kantronics MT1200, User Manual

Page: 116 / 157

This command sets the KISS address of the radio port in the MT1200. A KISS frame
with the upper nibble of the command byte set to this value will address this MT1200.
See also: INTFACE, KISS operation section
MYREMOTE xxxxxx-n (n = 0-15)
default (blank)
This command sets the callsign used for remote access of the TNC. Enter up to six
characters (plus optional SSID) which is different than used for MYCALL, or MYALIAS.
In addition, the RTEXT must be programmed with a text string. A station that connects
will be sent a series of numbers that must be decoded according to RTEXT.
See also: RTEXT; Remote Access section
NEWMODE {ON | OFF}
default ON
When ON, the TNC will return to Command Mode if the a disconnect occurs.
When OFF, a disconnect will not cause the TNC to change modes.
See also: CONNECT, DISCONNECT, STATUS
NOMODE {ON | OFF}
default OFF
When OFF and a connection takes place, the TNC will change to whatever mode is
specified in CONMODE. When ON, the TNC stays in Command Mode after connecting
to another station; that is, it does not immediately change to Convers or Transparent
Mode.
See also: CONMODE, CONNECT
PACLEN n (n = 0 - 255)
default 128
108