DN1769-1809
32
8 - Hardware Default initialization
Note:
The Soft Reset and the Hard Reset can be performed directly from the VUI, without having to open the KTES,
refer to the
KTES Programming Manual
, DN1770.
8.1 How to reset the Kantech Telephone Entry System for Factory
Default
Before you start, you must be able to:
•
Open the KTES with the key.
•
Locate the reset button (SW1) and the two jumpers JP1 - JP2.
•
See the flashing blue
Heartbeat
LED.
1. Remove JP1 and JP2 jumpers as described in
2. Press the reset button.
3. Check the blue
Heartbeat
LED pattern, wait until the heartbeat pattern corresponds to this:
4. Put back JP1 and JP2 jumpers, close and lock the KTES.
5. Configure the KTES with the VUI, refer to the
KTES Programming Manual
, DN1770.
Figure 12: KTES Factory Default Steps
Continuous LONG pulses
Summary of Contents for Telephone Entry System
Page 1: ...DN1769 1809 Installation Manual Kantech Telephone Entry System ...
Page 2: ......
Page 4: ...DN1769 1809 iv ...
Page 40: ...DN1769 1809 34 ...
