DN1611-1809
29
KT-NCC Installation Manual
Configuring with a Static IP Address
Communication between the EntraPass Global server and the KT-NCC(s) will be done through a static IP
address. The network administrator must provide all the information in order to complete the
configuration, see Configuration Information Sheet on page 44.
You can assign an IP address with 2 different tools: The Web Configuration Page and the KT-Finder.
Using the Web
Configuration
Page
Before you start:
NEVER
use the address 192.168.0.2 for the computer used to configure the KT-NCC.
This IP address is assigned by default to Ethernet port #2 for the KT-NCC Web Configuration Page. The
IP address of the computer must be within the same segment. For example, 192.168.0.x, where x can be
any number between 3 and 256.
Important:
Make sure that your
network cable
is
NOT
connected to the
Ethernet Port #1
1. Connect the crossover cable to the Ethernet Port #2. Start the browser.
Figure 14: IP Address location
2. Enter the default IP Address of your KT-NCC in the
Address field.
(
192.168.0.2
), and press
Enter
on
your keyboard. The KT-NCC Web Configuration Page will open.
Figure 15: KT-NCC Web Configuration Page
3. In the
EntraPass Server
section, enter the
EntraPass Server IP Address
.
