DN1611-1809
23
KT-NCC Installation Manual
Resetting the KT-NCC
For maintenance purposes, the KT-NCC may need to be reset. Three types of resets can be performed
on the system: Soft reset, hard reset and factory reset.
Please refer to Figure 22: on Page 39 to locate the different components of the KT-NCC board required
to perform system resets.
Table 6:
:
KT-NCC Reset Types
Reset Type
Instructions
Soft Reset.
A soft reset will only re-initialize the status.
1. Press the
Reset
button.
Hard Reset
A hard reset will reset the KT-NCC to it’s default values but will keep
the IP address intact.
1. Use the needlenose pliers to remove
jumper JP2
.
2. Press the
Reset
button.
3. You must wait until the blue LED starts to flash again
(approximately 15 seconds) before you put
jumper JP2
back in
place.
Factory Reset
We strongly suggest that you call Kantech Technical Support
before performing a factory reset on your system.
A factory reset will clear all KT-NCC configuration including the IP
address.
1. Use the needlenose pliers to remove jumpers
JP2
and
JP3
.
2. Press the
Reset
button.
3. Put
jumpers JP2
and
JP3
back in place.
