DN1611-1809
13
KT-NCC Installation Manual
Pre-Installation
Before installing the KT-NCC, confirm that all parts are in order, all necessary tools are available, and that
the site is properly prepared.
If you are connecting your KT-NCC to the EntraPass Global Edition software, you must make sure that
you are running version 3.17 or higher.
Equipment
Checklist UL
Only
Note:
The equipment checklist is not required for the
KT-NCC-EU
since it is fully assembled by
Kantech.
•
KT-NCC-CAB: Cabinet with inner door sticker UL, DN1642,
•
KT-NCC-PCB: KT-NCC-PCB with accessory kit KT-NCC-PCB-ACC and
KT-NCC,
Installation Manual
, DN1611,
•
KT-NCC-ACC: Accessory kit with VC-485 adapter cable,
•
KT-TAMPER: Tamper Switch,
•
An AC transformer 16.5 VAC, 40 VA, class 2 wire-in or plug-in transformer.
The Kantech
TR1640P/UL
(in USA) or
TR1640P/CSA
(in Canada) is recommended.
•
Kantech 3-LED plate part number
KT-3LED-PLATE
for remote alarm monitoring
Additional Parts
Along with these parts, the following items will be needed to correctly install the KT-NCC:
•
One
KT-BATT-12
, 12V/7Ah battery,
•
RJ-45 Network cable(s)
Tool Checklist
The following tools will be required to install the KT-NCC:
•
Small screwdriver (included in the KT-NCC-ACC and KT-NCC-PCB-ACC kits)
•
0.65 cm (0.25 in) nut driver
•
Wire strippers
•
Small needlenose pliers
Reading
Checklist
We strongly suggest that you keep the following documents close at hand:
•
EntraPass Global Edition Reference Manual
, DN1316
•
KT-NCC Quick Configuration Guide
, DN1656
•
How to Migrate from a Windows Global Gateway to KT-NCC Application Note
, DN1661
•
To Upgrade EntraPass Global Edition from Version 1 to Version 3 Application Note
, DN1541
•
Upgrading NCC8000 to NCC Windows Application Note
, DN1567
•
Setting Up EntraPass Mirror Database and Redundant Server Application Note
, DN1317
•
Lantronix UDS-10 Setup Instructions Application Note
, DN1506
•
Lantronix UDS1100 Setup Instructions Application Note
, DN1665
Site Checklist
Ensure the following:
•
The mounting site is ready. The upper mounting screws should be 25.65 cm (9.9 in) center to center,
the bottom mounting holes are 31.50 cm (12.40 in) below the upper mount holes.
•
The site has been inspected and all wiring complies with UL or CE requirements and other codes as
appropriate.
•
All preliminary site work is completed and the site is clean and free of dust or other contaminants.
