KANSAI SPECIAL DLR Series, Parts List, Instructions

Page: 46 / 52

5
DLR
series
【 4 】 LUBRICATION
4-1 Oil
Use Kansai Special’s genuine oil.
(Part No. 28-611)
4-2 To fill the machine with oil
Remove oil plug A.
Fill the machine with oil until the oil level is at the
top line (see H in the illustration) on oil gauge C.
After the first lubrication, add oil so that the oil level
will be between H and L.
After filling the machine with oil, tighten plug A and
run the machine to check the oil is splashing onto oil
pot A.
4-3 Replacing the oil and the filter element
To extend machine life, be sure to replace the oil after
the first 250 hours of operation.
To replace the oil, follow the procedures below.
1. Remove the V belt from the motor pulley and
then remove the machine from the table.
2. Remove screw D and then drain the oil.
Be careful not to stain V belt with the oil.
3. After draining the oil, be sure to tighten screw
D.
4. Fill the machine with oil by referring to 4-2
shown above.
If filter element E is contaminated, proper oiling may
not be performed. Clean the filter element every six
months.
If just a little or no oil flows out from the nozzle with the proper amount of oil in the machine,
check the filter element.
To clean the filter element, remove oil reservoir.
6
DLR
series
【 5 】 SEWING MACHINE INSTALLATION
5-1 Cutting the machine able