Kannad S185 501 Series, Maintenance Manual

Page: 1 / 8

Component Maintenance Manual
P/N S185X501-XX
25-63-06
Page 7001
© KANNAD 2011
JUN 16/2011
ASSEMBLY
TASK 25-63-06-400-801-A01
1. General
A. Introduction
(1) This section gives the procedures for the assembly of the equipment. The components are
identified by their “Figure - Item” number in the Illustrated Parts List (
Refer to Figure 10001 / 25-
63-006-991-010-A01 ).
(2) Assemble the unit in a clean, dust-free area in accordance with the procedure that follows. Use
good standard workshop practices.
(3) Examine the parts ( PAGEBLOCK CHECK ) before you start the assembly.
B. Special Instruction
CAUTION: BEFORE WORK ON THE ELT, MAKE SURE THAT THE FRONT PANEL SWITCH IS
SET TO “OFF”.
C. Tools, Fixtures and Equipment
(1) Special Tools, Fixtures Equipment List
Refer to PAGEBLOCK SPECIAL TOOLS, FIXTURES, EQUIPEMENT AND CONSUMABLES .
D. Annual Inspection Kit
NOTE: the parts of the annual inspection kit are also included in the battery kit P/N S1840510-01.
For this reason, it is not necessary to use an extra annual inspection kit when a battery kit
is used. When a battery kit is used, all the parts must be used excepted two screws and the
label EES1923.
(1) Annual Inspection Kit Content
Table 7001 / 25-63-06-992-901 : Annual Inspection Kit Content
(2) Use of the annual inspection kit
NOTE: The purpose of the annual inspection kit is to replace the necessary parts when the
ELT is opened without battery replacement.
KIT PAR NUMBER S1840510-02
Part Number DESIGNATION Numbers
0141822 O-RING 1
0123831 CAPSULE,DESICCANT 1
0145234 SCREW, F HEXALOB. M3x16 A4 4
0146261
SCREW, F HEXALOB. M3x20A4
[only used for AP, AP (ER), AP-H, AP-H (ER)] 2
0136779 NUT, NYLSTOP M3 A4 4
0141787 LABEL, SEAL 1
0145250
LABEL, INSPECTION EES1923
[not used for INTEGRA ELTs]
1
0145251 LABEL, INSPECTION EES1928 1
The document reference is online, please check the correspondence between the online documentation and the printed version.