Kannad 406 AP-H, Operation Manual

Page: 42 / 60

INSTALLATION MANUAL OPERATION MANUAL
KANNAD 406 AP-H
PAGE 210
JUL 24/2013
4. First power up
Perform the following tests:
1. ELT operational tests:
• connect RCP to J1 and outside antenna to J2;
• switch the ELT from OFF to ARM;
• check that the Self-Test result is OK (one long flash).
2. RCP operational tests:
Refer to 3. RCP operational tests, page 303 .
3. 406 & 121.5 MHz transmission tests (optional):
Refer to 4. 406 and 121.5 MHz transmission test, page 304 .
At the end of the first power up procedure, switch the ELT to ARM.
The ELT is now in stand by mode and ready to be activated either automatically
by G-Switch sensor if a crash occurs or manually by RCP (if any).
Note : switching to ON directly on the ELT front panel will also activate
the ELT.
5. Removal
• Switch the ELT to OFF ( Refer to Figure 205: Installation, controls and
connectors ).
• Disconnect the Remote Control Panel (or CS144) from the DIN12
connector ( Refer to Figure 205: Installation, controls and connectors ).
• Disconnect the outside antenna from the BNC connector ( Refer to Figure
205: Installation, controls and connectors ).
• Unfasten the self-stripping strap.
• Remove the auxiliary antenna.
• Remove the transmitter from the bracket.
Figure 207: Removing the transmitter