INSTALLATION MANUAL OPERATION MANUAL
KANNAD 406 AP-H
PAGE 109
JUL 24/2013
1.
Switch to "OFF".
2.
Disconnect the external antenna (ANT) and the Remote Control Panel
(RC).
3.
Unfasten the Velcro® strap.
4.
Remove the transmitter and the auxiliary antenna from the bracket.
5.
Connect the auxiliary antenna (ANT).
6.
Switch to "ON":
- Important: Put the antenna in a vertical position.
- The ELT starts with the self-test sequence.
- 121.5 / 243 MHz transmission starts immediately after the self-test.
- 406 MHz transmission starts after 50 seconds.
- During transmission, buzzer operates and visual indicator flashes
periodically.
8. Reset
It is possible to stop the ELT in case of unintentional activation.
Important notice: As 406 MHz transmission is effective 50 seconds after
the ELT activation, if it is reset within this delay, no further radio contact
will be necessary.
A. Manual reset
• Switch to " OFF ".
B. Reset with Remote Control Panel
• The switch has to be in the "ARM" position on the ELT.
• Switch to " RESET & TEST" on the remote control panel.
9. Self-Test
Refer to 1. Self-test, page 301
Regulations state that no transmission must be interrupted unless
every means are used to contact and inform the Air Traffic Controller
of this action.
OFF
ANT
TST
OFF
ON
RC
