8
2.2 Hardware Setup
Follow these instructions to connect the Defender drive to your computer:
1. Remove the USB cable from the side of the Defender. The easiest way to release the cable is by
pulling out the USB A side first, as shown in the image below.
2. On the other side of the drive, pull open the rubber USB cover to reveal the USB port.
3. Connect the Micro B side of the USB cable to the Defender’s USB port. Connect the A side of the
USB cable to your computer. The LED indicators on the side of the drive will light up. You are now
ready to begin using your Kanguru Defender drive.
↓
↓
USB A
to computer
USB Micro-B
to drive
Note:
If your Defender HDD is not recognized by your computer when plugged in, it may not be
drawing enough power from a single USB port. Please use the provided Y-type USB cable to connect
the device through two USB ports.
Hardware Setup
↓
