3x1 Wall plate Extender & Switcher with HDMI 2.0 and USB-C
6
⑩
FIRMWARE:
Micro-USB port for firmware upgrade.
⑪
USB-C:
Type-C USB to connect the MacBook or other device with USB-C output.
⑫
USB-C LED:
The LED illuminates orange when the
USB-C
port is connected to a
source device, and it will turn green once the device is selected as input source.
⑬
DISPLAY ON/OFF:
Turn the display ON or OFF via CEC or RS232 (Programming
required). For more details, please refer to the
on the page 7.
⑭
SOURCE AUTO:
✓
Press the backlit button to select the next input source.
✓
Press and hold the button at least 3 seconds to enable auto switching mode.
For more details, please refer to the
on the page 7.
3.2
Rear Panel
①
HDBT OUT (POC):
RJ45 HDBaseT output port to connect to the HDBT IN port of
the receiver by a CATx cable. It supports 12V-48V PoC to enable the switcher can
be powered from a compatible receiver.
②
DC IN:
Power port to connect 24V DC power adapter.
③
DC OUT:
2-pin terminal block to connect a compatible device which needs to be
powered.
④
IR IN:
2-pin terminal block to connect IR control center for broader solution.
⑤
RS232:
3-pin terminal block to connect a control device (e.g. PC) to send the
RS232 command to control this unit, or to control the far-end third party device. For
more details, please refer to the
on the page 8.
P
o
C
H
D
B
T
O
U
T
R
S
2
3
2
IR
IR
I
N
D
C
O
U
T
D
C
I
N
1
4
5
2
3
