Emsis — Manual
2.4
Installing New Layout
1. Use
screen selector
to switch to the Emsis
Setup screen
.
2. Select the
Service
option. Enter
314
for the password.
3. Select the
Firmware update
option from the list. This will
start the automatic firmware update procedure. It will update
firmware in detected devices one by one. The procedure may
take a few minutes.
4. Once finished, close all windows.
2.4
Installing New Layout
Emsis screen can be configured in many different ways, depending on
the engine, other connected devices, specific sensors, etc. The engine
limits and screen organization are stored in a layout file. Layouts are
prepared by Kanardia and sent to users when requested.
Follow the steps below in order to copy a new layout to Emsis.
1. A layout file is usually sent by e-mail to the user. Copy the file
to the micro SD card. Do not open or change the file on the
PC.
2. Make sure to use the
Safe remove
option on PC before remov-
ing the card from PC.
3. Insert the card into Emsis and change to the
Emsis Setup
screen.
4. Select
Service
and enter
314
password.
5. From the list of items, select the
Import layout
.
6. This will list layouts/configurations found on the card. Select
the one you need, then press the
OK
button. This will copy the
layout from SD card and activate it.
14
©
Kanardia
2021
