20
11. setup via front keys
Date, time and primary M-Bus address can be adjusted by means of the keys on the
calculator's front.
1
In the display you select the reading you want to change
2
Lift off the calculator top
3
Wait until the meter has shut down (up to 2.5 minutes). Do not press any keys
4
While remounting the calculator top, keep the main key activated
until there
are no more lines in the display.
5
The setup menu is now active.
Having activated the setup menu the reading you want to change is displayed with
the rightmost digit flashing:
The value of the flashing digit can be changed by pressing the sub-key
. The digit
is increased by one each time the key is pressed, and passing 9 you start from 0:
Pressing the main key
you go to the next digit from right to left:
The active digit flashes and this digit can now be changed by pressing the sub-key
. You go to the first digit on the right by means of the main key
.
When the value of the reading has been changed you quit by pressing the main key
continuously for approx. 10 seconds.
It should be checked whether the value is valid for the reading in question. If so, the
value is saved and an “OK” symbol is displayed. If not, the old value is maintained,
no ”OK” symbol appears, and the display reverts to legal reading.
5512952_B2_GB_01.2012