The first time it is started, the machine will be fairly
noisy, due to the normal breaking-in stage of the
transmission gears. This noise will disappear after
approximately 8 machine hours; in any case, the
measurable noise level is equal to and not greater
than 78 dbA.
IT IS ABSOLUTELY FORBIDDEN:
to lubricate the blade (saw)
before/during/after cutting;
work without the blade guide installed and
positioned properly;
work without the rear guard;
hold the piece to be cut by hand.
THE MANUFACTURER SHALL NOT BE HELD
LIABLE:
For damage of any type or entity caused by
irrational use of the machine, failure to observe the
safety rules indicated in this manual or tampering
with the machine, however slight. These actions
will also invalidate all warranty coverage.
5.2 Cutting Speed (FPM)
(Dial Speed is measured in Meter per Minute)
FPM
MPM
Stainless Steel:
65-163
20-50
Copper, Aluminum
and its Alloys:
163-260
50-79
Steel, etc.:
260-357
79-109
Clamp the piece to be cut in the vise securely.
5.3 Adjusting the Blade Guide (fig.3)
Loosen the lever (24).
Slide the blade guide (25) which also acts as a
protection until the saw (26) is as covered as
possible, based on the size of the part to be cut.
5.4 Operator Position
The placement of the machine in relation to the
operator position must make it possible to
observe the results of the operation and maintain
safety conditions.
During this stage, make sure the start button (8)
and speed regulator (9) are easily accessible, and
that there is sufficient visibility and lighting on
the tool, the surrounding area and base.
It is strictly forbidden to place and/or
use the saw when environmental
conditions constitute a hazard of explosion or
fire. It is forbidden to use the machine for any
purpose other than that intended by the
manufacturer. Make sure that operation of the
saw does not create hazardous situations for
people and/or property. Should you encounter a
malfunction, stop the machine immediately and
check the reason for and/or extent of the
breakdown. Contact the authorized Technical
Service if necessary to exceed the cutting
capacity stated by the manufacturer.
5.5 Starting
Release the safety switch by turning the lock
(orange) down (8) then press and begin cutting
using even pressure.
6. Caution
