Kalmar TL2, Maintenance Manual, Page: 88 / 216

4 Fill the filter with clean engine oil. See chapter
Specifications
for the oil requirements.
CAUTION
The lack of lubrication during the delay until the filter is pumped full
of oil at start-up may cause damage to the engine.
5 Apply a light film of lubrication oil to the gasket surface of the
oil filter.
NOTE
Be careful that no debris is poured into the filter. If using an oil supply
with a metallic or plastic seal under the cap, be careful to peel the
seal back. Puncturing the seal with a knife or sharp object can create
debris in the oil container.
6 Install the filter onto the oil filter head. Tighten the filter until
the gasket contacts the filter head surface.
7 Tighten 3/4 to 1 turn after the gasket makes contact with the
filter head.
40 1 Engine – 1.8 Lubrication system
TL2 Maintenance Manual
591 003 Default