Kalkhoff Bosch Cruise, User Manual

Page: 202 / 550

20 VI User Manual | Impulse Ergo Pedelec
5.1.7 Troubleshooting
If your bike has been exposed to wet conditions for
an extended period, e.g. after a trip in heavy rain, or
if there have been large differences in temperature,
the screen of the display may steam up. This mois-
ture does not impair the function of the display. It is
comparable with the steam on a pair of glasses when
you enter a warmer room having been outside. After
a short time in drier and warmer conditions, this con-
densation will vanish leaving no trace.
TEXT CAUSE SOLUTION
“ Speed sensor signal
missing”
Spoke magnet has slipped out of
position
•
Make sure the spoke magnet has not slipped.
It should be as close as possible to the sensor
on the chain stay (max. 5 mm clearance).
1
2
1 Spoke magnet
2 Sensor on chain stay
Speed sensor defective
•
Please contact your specialist cycle shop.
Cable connection defective
•
Please contact your specialist cycle shop.
“ Battery communication
error”
No connection between motor
unit and battery
a. Connect the battery to the charger.
b. Use a different battery.
c. Have your specialist cycle shop check the
control cable that runs from the battery plug
to the motor unit.
“ Motor temperature is too
high”
The motor has become too hot,
e.g. as a result of a long, steep
incline ridden in a high gear.
•
Allow your system to cool down before resum-
ing your journey.
“ Battery temperature is too
high”
The battery has become too hot.
•
Allow the battery to cool down for a while by
not riding or by riding without assistance.
If necessary, place the battery in the charger
for a minute.
5.2 Setting and programming the
display
You can switch between the various displays within the
information area (also referred to as the “main menu”) by
pressing the Set button.
Pressing and holding the Set button will take you from any
display in the information area to the menu sub-items:
•
Delete trip data
•
Delete overall data
•
Device settings
•
Target cost
•
ERGO settings
•
Back