GES1337 KeyMander 2 3Play User Manual
114
should turn on and display a yellow light. If it is a charge only cable, it will
show a blue light which means it is still in wireless mode and does not
recognize the cable.
Xbox One
If the KeyMander 2 is connected to an Xbox One console and completely
stops responding to the keyboard and mouse or if this is a first time setup and
the keyboard and mouse are not working, start by making sure you have the
KeyMander 2 connected to the rear USB port on the console, as the front or
side ports do not support as much power output. Next, make sure you have a
game profile for Xbox One synced to the KeyMander 2 and you are in Mode
1 of that profile (Mode 4 is Crossover Mode so keyboard and mouse function
will not operate). If there is a profile for Xbox One current synced, the
KeyMander 2 LED status bar should be glowing green. If the status bar is
glowing green and the keyboard and mouse are still not working, check the
micro USB cable as mentioned above in Micro USB Cable Problems. If if
still does not respond, check the controller’s USB connection as described
below.
Loss of USB Connection to Controller
In the event the KeyMander stops responding to the keyboard and mouse,
you can check the USB connection to controller by opening the Xbox menu,
going to System > Settings > Devices & Streaming > Accessories. When the
Xbox controller is displayed on the screen, select the three dots below the
Configure box. Select the Firmware Update even if “No update available” is
displayed. Select Continue. If you see a message saying to insert batteries or
connect a USB cable after pressing continue and it will not attempt to update,
the controller is connected to Xbox One in Bluetooth mode and you will need
to follow the steps below to switch it to USB communication.
1.
Disconnect the controller from KeyMander 2 3Play.
2.
Disconnect KeyMander 2 3Play from the Xbox One console.
3.
Disconnect the external power cable from KeyMander 2 3Play (if
attached).
4.
Press and hold Xbox power button on console for 10 seconds until the
console shuts down.
5.
Unplug the power cable from the console for 1 minute.
6.
Reconnect power cable to the console and turn on using the power button
on the console. DO NOT press the power button on a controller.
Summary of Contents for GE1337P2
