Never take away the protective guard. Keep hold down the learance to the
minimum gap required to feed material.
Never use shear to cut rod or material exceeding its designed capacity.
Never attempt to shear any material less than a 1/2
″
cut across the full length of
the table under full capacity.
5. OPERATION INSTRUCTION
5.1 The chart below is a material conversion comparison to show equivalent
capacities of material other than mild steel.
Model 37
″
Model 52
″
MILD STEEL GAUGE
1.0mm
1.5mm
ALUMINUM
1.8mm
2.5mm
BRASS YELLOW
SOFT
1.2mm
1.8mm
1/2HARD
1.1mm
1.6mm
HARD
1.1mm
1.6mm
NRONZE PHOSPHOR
ANNEALED
1.1mm
1.6mm
COPPER
SOFT
1.2mm
1.8mm
HARD
1.1mm
1.6mm
PLASTIC ABS COMPOUND
1.8mm
2.5mm