Fig. 30 Air filter maintenance
1
Air filter
2
Inlet air opening
3
Filter element
4
Retaining clip
5
Cover
1. Unscrew the air filter from the cylinder head.
2. Release the retaining clip and take off the cover.
3. Blow out the cover and filter element with dry compressed air (<5 bar).
4. Clean the housing and sealing faces.
5. Wet the filter element lightly with oil after cleaning.
6. Position the cover over the element and close the retaining clips.
7. Mount the air filter on the cylinder head so that the inlet opening is facing downwards.
8. Switch on the power supply disconnecting device.
10.5 Option H9
Air filter (sound damping) maintenance
Check that all sealing surfaces match each other. The use of an unsuitable air filter cartridge can
permit dirt to ingress into the pressure system and cause damage to the machine.
Material Compressed air for blowing out
Spares as required
Precondition Cut-off the electrical power supply via the power supply isolating device,
ensure that the device is locked off,
verify the absence of any voltage.
The machine has cooled down.
Fig. 31 Option H9: Air filter (sound damping) maintenance
1
Air filter cartridge
2
Inlet air opening
3
Retaining clip
4
Cover
10 Maintenance
10.5 Air filter (sound damping) maintenance
No.: 9_5752 24 E
Assembly and operating manual 1-stage piston compressor
EPC-G
69
