Kaden KCS Series, Manual, Page: 5 / 16

Kaden Remote Controller Manual | 5
3. Handling the remote controller
Inserting and replacing batteries
Your air conditioning unit comes with two AAA batteries.
Put the batteries in the remote control before use:
1. Remove the back cover from the remote control, exposing
the battery compartment.
2. Insert the batteries, paying attention to match up the (+)
and (-) ends of the batteries with the symbols.
3. Install the back cover.
Installing remote control holder
The remote controller can be attached to a wall or stand by
using a remote controller holder.
1. Before installing the remote controller, check that the air
conditioner receives the signals properly.
2. Install the holder with two screws.
3. Put the remote controller in the holder.
Battery notes
For optimum product performance:
• Do not mix old and new batteries, or batteries
of different types.
• Do not leave batteries in the remote controller if you don’t
plan on using the device for more than 2 months.
Battery disposal
Do not dispose of batteries as unsorted municipal waste.
Refer to local laws for proper disposal of batteries.
Tips for using remote control
• The remote control must be used within 8 metres
of the unit.
• The unit will beep when remote signal is received.
• Curtains, other materials and direct sunlight can interfere
with the infrared signal receiver.
• Remove batteries if the remote control will not be used
more than 2 months.
Remove the back cover
to install batteries
Put the remote controller
in the holder