NOTE
Setting values according to pictogram refer only to the blueplanet 125TL3 device type. For your device
please note the slider in the web interface.
9.5
Monitoring the device
The device has an integrated web server. This makes it possible to monitor and record the operating state and yield of
your PV system.
USB interface
Use an external USB storage device to read operating data saved on the device.
Reading log data
1 Connect a suitable USB storage device to the USB interface on the connection circuit board.
2 Open the “
Log data view
” menu.
3 Select "Save to USB".
4 Select the desired log data using the 4-way button.
5 Press the
Enter button
.
»
The device saves the selected log data to the USB storage device.
NOTE
The USB interface is approved solely for use with USB flash storage devices (“USB sticks”). The maximum
available current is 100 mA. If a device with a higher power requirement is used, the power supply for the
USB interface automatically shuts down to protect the device from damage.
Web server
This device has an integrated web server. After configuring the network and activating the web server in the Settings
menu, you can open the web server from an internet browser. The language version of the website delivered by the web
server is adapted dynamically to the pre-set language preferences in your Internet browser. If your Internet browser re-
quests a language that is unknown to the device, the web server uses the menu language set in the device.
↻
You have connected the device to your network.
1 When using a DHCP server: Activate DHCP.
2 For manual configuration (DHCP off):
3 Open the Settings/Network menu.
4 Assign a unique IP address.
5 Assign a subnet mask.
6 Assign a gateway.
7 Assign DNS server.
8 Save your settings.
Using the web server
To avoid problems with incompatibility, use the most recent version of your Internet browser. JavaScript must be enabled
in the browser settings to display the web server correctly.
NOTE
You can also access the web server of the device via the Internet. To do this, additional settings of your
network configuration, particularly your internet router, are required. Note that communication with the
device is carried out over an unsecured connection, particularly in the case of a connection via the internet.
↻
Configure the Ethernet interface.
Powador 30.0-72.0 TL3
Page 52
EN
