9
Connecting
The Vyper-KV25 and Vyper-KV52 feature euroblock 2 pin
Phoenix inlet for easy connectivity and link.
Caution must be taken when connecting the loudspeaker
cable to the flying connector to match the signal polarity:
+
HOT
red wire
–
COLD
black/blue wire
If a label with signal polarity is not present on the flying
connector, please refer to the label on the loudspeaker
rear panel.
For a cable run of up to 5 m (16.4 ft) use wire gauge of
0,75 mm
2
(18 AWG) at least.
For longer cable runs a wider gauge is recommended.
For the Vyper-KV52, the input signal can be fed either in the
top or in the bottom input connector.
Vyper-KV25
Low: 8
Ω
High: 32
Ω
Vyper-KV52
Low: 16
Ω
High: 64
Ω
Connecting Multiple Vyper-KV52
The top and the bottom connectors of the Vyper-KV52 are
paralleled so that the input signal can pass through the
loudspeaker to fed another Vyper-KV52.
A proper jumper wire must be prepared to fed the signal in
the loudspeaker joined in line array configuration (see Joining
Multiple Vyper-KV52).
Joining the loudspeakers set them in parallel (see paragraph
Loudspeakers in Parallel, p. 10).
Impedance Settings
Both the Vyper-KV25 and the Vyper-KV52 feature selectable
impedance. Selecting the proper impedance allows the
loudspeaker to match the amplifier requirements, especially
when connecting multiple loudspeakers in parallel (see
paragraph Loudspeakers in Parallel, p. 10).
A switch on the rear panel toggles the loudspeaker’s load
impedance between two values.
6 mm (0.23 in)
Jumper wire
25 mm (1 in)
12 mm (0.5 in)
6 mm (0.25 in)
Vyper
User Guide
