19
negative retaining clip. The battery should easily snap into position.
9. Replace the hard drive.
10. Reinstall the embedded controller into the PXIe chassis and restore power.
2.3.15 Clearing CMOS Jumper (JP1)
In the event of a system malfunction causing the PXIe-63975 to halt or fail to boot, clear the
CMOS and restore the controller BIOS to its default settings. To clear the CMOS:
1. Shut down the controller operating system. Turn off the PXIe Chassis.
2. Remove the PXIe-63975 from the chassis. Observe all anti-static precautions.
3. Locate the JP1 jumper on the board. Move the jumper from Normal to Clear (short
pin#2 and pin#3), as shown.
4. Remount the controller into the PXIe chassis.
5. Power on the chassis and immediately depress the Reset button on the faceplate,
before any monitor display appears.
6. After the operating system starts, shut down the controller operating system and
power down the PXIe chassis.
7. Once again, remove the PXIe-63975 controller from the chassis.
8. Restore jumper JP1 to the Normal position (short pin#1 and pin#2).
9. Remount the controller into the PXIe chassis and restorepower.
