PCIe/PXIe-6302 |
| 38
Figure 33 Retrigger Paraments
You can use three different kinds of triggers in this program as mentioned in this
chapter.
Start Trigger
and
Reference Trigger
can be set by
Trigger Mode
. For
Re-Trigger
it can be used by changing the numbers in
Retrigger Count
.
Now the
Trigger Mode
is “
Reference
”, and the
PreTrigger Samples
are 10. Click
Start
to begin the data acquisition, the result is shown below:
Figure 34 Retrigger In Reference Trigger Mode
Because the measured waveform is an irregular continuous line, the effect of
Trigger mode
change can not be seen clearly.
Now change the mode of trigger to
Retrigger
through giving
Retrigger Count
the
number 3 and click
Start
. A message will appear in the lower left corner:
“Samples acquired: 200/300”.
Figure 35 Retrigger Complete State
It shows the acquisition process through every trigger signal.
Summary of Contents for PCIe/PXIe-6302
