JVC VN-H657U, Instructions Manual

Page: 64 / 98

[Multicast] Page
This page is for setting manual multicast
transmission.
This page can be used during access using
“admin” or “operator”.
0 Press the [OK] button to save changes made on
this page.
0
If the [OK] button is pressed upon entering an
invalid value, a warning message will appear
and the entry will be denied. Press the [Cancel]
button to restore the invalid entry to the value
before the change was made. If you press the
[Cancel] button, other changed items will also be
restored to the values before the change was
made.
Memo :
0
When the power of the camera is turned off
accidentally during multicast transmission,
multicast transmission will restart automatically
after the camera is rebooted.
Settings
.
* Setting values with
R
are default values.
Encoder No.1 to No.3
For setting manual distribution by Encoder No.1 to
No.3.
Memo :
0
Only the setting options for the encoder in
operation will be displayed.
9
Encode
Displays the [Encode] settings specified for each
encoder.
(
A
P45 [[Encoding] Page] )
[Displayed values: JPEG, H.264 Baseline, H.264
High]
9 Framesize
Displays the [Framesize] settings specified for
each encoder.
(
A
P47 [ Framesize ] )
9 Framerate
Displays the [Framerate] settings specified for
each encoder.
(
A
P47 [ Framerate ] )
The frame rate can be changed when Encode is set
to “JPEG”.
[Set values:
R
30 fps, 15 fps, 10 fps, 7.5 fps, 5 fps,
3 fps, 2 fps, 1 fps, 1/2 fps, 1/3 fps, 1/5 fps, 1/10 fps,
1/30 fps]
Memo :
0
You can specify a frame rate that does not
exceed the upper limit specified in the [Basic
Setting2] page or [Encoding] page.
(
A
P45 [[Encoding] Page] )
9 Destination Address
For specifying the destination address for
distribution by the preset encoder.
Specify the multicast address. When other devices
that make use of multicast transmission exist,
ensure that each of them is set to a different
multicast address.
[(Factory default) Encoder No.1: 225.0.1.1,
Encoder No.2: 225.0.2.1, Encoder No.3:
225.0.4.1]
9
Destination Port
For specifying the destination port number for
distribution by the preset encoder.
Specify an even number for RTP compliance.
When other devices that make use of multicast
transmission exist, it is recommended that each of
them be set to a different port number.
Multiple multicast streams cannot be received on
a single computer when there are duplicate port
numbers.
[(Factory default) Encoder No.1: 49152,
Encoder No.2: 59152, Encoder No.3: 29152]
9
Start
Saves the encoder settings and starts manual
distribution.
It is displayed as a [Stop] button during distribution.
The frame rate, destination address, and
destination port cannot be changed while
distribution is in progress.
64
[Advanced Settings] Page - [Multicast] Page
Se
tti
ng
Us
in
g In
ter
net
E
xplor
er