JVC VN-H657BU, Instruction Manual

Page: 77 / 120

[Multicast] Page
This page is for setting manual multicast
transmission.
All items can be set when you log in as “admin”.
If you log in as “operator”, you are only allowed to
start or stop transmission.
0
When you are logged in as “admin”, press the
[OK] button to save changes made on this page.
0
When you are logged in as “admin”, a warning
message will appear if you press the [OK] button
upon entering an invalid value, and the entry will
be denied. Press the [Cancel] button to restore
the invalid entry to the value before the change
was made. If you press the [Cancel] button,
other changed items will also be restored to the
values before the change was made.
Memo :
0
When the power of the camera is turned off
accidentally during multicast transmission,
multicast transmission will restart automatically
after the camera is rebooted.
Settings
.
* Setting values with
R
are default values.
Encoder No.1 to No.3
For setting manual distribution by Encoder No.1 to
No.3.
Memo :
0
Only the setting options for the encoder in
operation will be displayed.
Encode
Displays the [Encode] settings specified for each
encoder.
(
A
p.52 [[Encoding] Page] )
[Displayed values: JPEG, H.264 Baseline, H.264
High]
9 Framesize
Displays the [Framesize] settings specified for
each encoder.
(
A
p.54 [ Framesize ] )
9 Framerate
Displays the [Framerate] for multicast
transmission.
The frame rate can be changed when Encode is set
to “JPEG”.
[Set values:
R
30 fps, 15 fps, 10 fps, 7.5 fps, 5 fps,
3 fps, 2 fps, 1 fps, 1/2 fps, 1/3 fps, 1/5 fps, 1/10 fps,
1/30 fps]
Memo :
0
You can specify a frame rate that does not
exceed the upper limit specified in the [Basic
Setting2] page or [Encoding] page.
(
A
p.52 [[Encoding] Page] )
Destination Address
For specifying the destination address of multicast
transmission.
Specify the multicast address. When other devices
that make use of multicast transmission exist,
ensure that each of them is set to a different
multicast address.
[(Factory default) Encoder No.1: 225.0.1.1,
Encoder No.2: 225.0.2.1, Encoder No.3:
225.0.4.1]
Destination Port
For specifying the destination port number for
multicast transmission.
Specify an even number for RTP compliance.
When other devices that make use of multicast
transmission exist, it is recommended that each of
them be set to a different port number.
Multiple multicast streams cannot be received on
a single computer when there are duplicate port
numbers.
[(Factory default) Encoder No.1: 49152,
Encoder No.2: 59152, Encoder No.3: 29152]
Start
Saves the [Framerate], [Destination Address], and
[Destination Port] settings, and starts manual
distribution.
It is displayed as a [Stop] button during distribution.
[Framerate], [Destination Address], and
[Destination Port] cannot be changed while
distribution is in progress.
[Advanced Settings] Page -[Multicast] Page
77
Se
tti
ng
Us
in
g In
ter
net
E
xplor
er