Tilt Limit
This item sets the movable range of the tilt (vertical)
operation during manual operation.
When this item is set to 10°, the movable range of
the tilt operation is from 10° to 90°. It cannot operate
between -5° and 9°.
When the [Auto Flip] item is set to “Digital Flip”, Tilt
Limit is also applied to tilt operations to 180°.
[Set values: -5
Degree to
R
0
Degree to 10
Degree]
Memo :
0
When the camera is moved to a prohibited area
by some operation for which priority is assigned
to Tilt Limit and manual tilting is performed, it
operates in the following manner.
0
Tilt operation is disabled in the prohibited
area. Tilt will be forcibly moved to the effective
area.
0
Once the camera enters the effective area,
the Tilt Limit settings take over and tilt
operation can only be performed in the
effective area.
0
It does not affect the Preset Position, Auto Pan
and Auto Trace operations.
Preset Position Speed
Speed
This item sets the speed of moving to the preset
position. It is also applicable when moving to the
preset position in Auto Patrol.
[Set values: Low, Mid,
R
High]
Auto Flip
Auto Flip
Set this item when shooting objects that pass right
under the camera.
The camera stops at the face down position when
vertical rotation is performed, the following
operations are necessary to shoot objects that
pass right under the camera.
A
Turn the camera to face down.
B
Rotate the camera 180° horizontally.
C
Turn the camera to face up.
You can use the [Auto Flip] function to perform the
above operations automatically.
0
OFF:
Auto Flip function does not activate.
0
Digital Flip:
The top/bottom and left/right of the image flips
when tilt position passed the angle of 135°.
0
Mode1:
When the camera faces bottom, it rotates 180°
horizontally and stops. In this case, the
operating direction of the camera is the same as
that of the Pan/Tilt operation.
0
Mode2:
When the camera faces down, it rotates 180°
horizontally and the camera operates in a
direction opposite to that of the Tilt operation.
Select this mode if you wish to operate
continuously. Once operation stops, the
direction will return to normal.
0
Mode3:
When the camera faces bottom, it rotates 180°
horizontally and the operating direction of the
camera is opposite that of the Tilt operation.
However, the operating direction will return to
normal 10 seconds after the operation has
stopped.
[Set values: OFF,
R
Digital Flip, Mode1, Mode2,
Mode3]
Memo :
0
The [Speed] settings for [Preset Position
Speed] are reflected as the rotation speed when
images are flipped using “Mode1”, “Mode2”,
“Mode3”. To flip images in high speed using
“Mode1”, “Mode2”, “Mode3”, set the [Preset
Position Speed] in [Speed] to “High”.
Note :
0
When [Auto Flip] is set to other than “OFF”, the
camera can be moved to areas outside the pan
limit with the Tilt operation. When “Digital Flip” is
set, use the Tilt operation to flip and return to the
pan limit area again. When “Mode1”, “Mode2” or
“Mode3” is set and the camera is moved to
inside of the pan limit with Pan operation, it will
stop at the pan limit position.
68
[Advanced Settings] Page - [PTZ] Page
Se
tti
ng
Us
in
g In
ter
net
E
xplor
er
