4
Pull the cables from the hole in the
wall.
0
Pull the power cable, LAN cable, alarm
signal cable, and audio cable from the wall.
.
Alarm signal
cable
Audio Cable
Power cable
LAN cable
Setting Up the Camera
1
Remove the dome cover.
0
Loosen the screws (x4) and remove the
dome cover from the camera.
.
Dome cover
2
Remove the lens cap and tape used
during transporting.
.
OFF
Heater ON/OFF
switch
Lens cap
Tape
Memo :
0
When installing the heater at an unrequired
location, turn off the ON/OFF switch of the
heater.
3
Insert the silica gels.
0
Be sure to insert the provided silica gels in
the position as shown in the diagram.
A
Loosen the screw and lift up the clamp.
B
Take out three silica gels from the aluminum
bag, and insert them into the back of the heater
(as shown in the diagram).
0
After inserting the silica gels, check that they
are not touching the heater.
C
Fix the silica gels firmly with the clamp, and
fasten the screw.
0
Turn the clamp until the silica gels are
secured, followed by tightening the screw.
.
Silica gel
x3
Screw
Clamp
Clamp
Heater
Heater
Fasten the silica gels firmly
with the clamp
Memo :
0
During reconnection or re-installation after
repair or maintenance, make sure to replace the
silica gels with new ones.
0
Consult our service center on the replacement
procedures. Use the silica gel with a service part
number of LW40500-001A for the part to be
replaced.
Note :
0
If silica gel is not inserted, the camera lens and
dome cover may turn foggy, and the camera
image may not turn out clear.
0
When installing on a rainy day, ensure that
raindrops do not enter the interior.
32
Installation and Connection Preparations (VN-H657WPBU)
Moun
tin
g
the
Ca
m
era
