JVC VN-H237VPU, Instructions Manual

Page: 70 / 114

70
Internet Explorer Setting
LED State Page
This page sets the [STATUS] LED indication of the camera.
This page can be used during access using
A
admin
B
or
A
operator
B
.
Memo:
●
Press the [OK] button to enable the new settings. If you press the [Cancel] button, your changes are
canceled and the current camera settings are displayed.
* The [Set values] in bold letters are factory defaults.
Settings (continued)
A
B
Click [Advanced Settings] and [LED State].
Status LED Allow to check and set the [STATUS] LED indication of the camera.
A
LED State Turns the [STATUS] indicator On or Off when the camera is operating.
Enable : Continues to light when the camera is operating.
Disable : Turns the indicator Off after the camera has started.
[Set values: Enable , Disable ]
B
Identify Unit If you wish to blink the [STATUS] indicator of the camera, set this option to
A
Blink
B
. This may occur if you wish to visually check the camera operation
when configuring the camera from the PC.
[Set values: Enable , Blink ]
Memo:
●
If you have set the [LED State] to
A
Disable
B
, the indicator does not light
even when you set the [Identify Unit] to
A
Blink
B
.