JVC VN-H237VPU, Instructions Manual

Page: 63 / 114

63
Time Page
This page sets the current clock time.
This page can be used during access using
A
admin
B
.
Memo:
●
Press the [OK] button to enable the new settings.
●
If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the
entry will be denied. Press the [Cancel] button to restore the invalid entry to the value before the
change was made. If you press the [Cancel] button, other changed items will also be restored to the
values before the change was made.
* The [Set values] in bold letters are factory defaults.
A
B
C
D
E
F
Click [Advanced Settings] and [Time].
A
SNTP Sets the SNTP client function.
ON
:Gets the time by periodical accessing to the specified NTP server.
OFF :Does not access to NTP server.
[Set values: OFF , ON ]
Memo:
●
The time is recorded in the JPEG header when distributed by the camera.
The time recorded in the JPEG header may not continue immediately
before and after the acquisition of time from NTP server.
B
SNTP Server Sets an IP address of NTP server.
[Factory default: 0.0.0.0]
C
Interval Sets a unit and values of measurement for the time interval at which to
access the NTP server.
[Set values: min (1 - 60), Hour (1 - 24) , Day (1 - 31) ]
D
Time Displays the clock time of camera.
You can correct the time by entering a value (without seconds).
Memo:
●
The time is recorded in the JPEG header when distributed by the camera.
Discontinuity may occur in the JPEG header's time immediately before
and after changing the time.
●
Stop recording to an SD card before changing the time. Changing the
time while recording to an SD card causes times to overlap and jump,
which may result in problems during playback.
E
Time Zone Sets a time zone.
[Set value: (GMT-12:00) - (GMT) UTC - (GMT+12:45) ]
F
PC Time to Camera Click [Set] to set the PC's time on the camera.