1-24 (No.MB551)
3.2.10 Removing the feed motor
(See Figs.18 and 19)
• Remove the tray assemblies and DVD traverse mechanism
assembly.
(1) From the top side of the DVD traverse mechanism assem-
bly, remove the screw
K
attaching the feed bracket and re-
move the feed bracket from the sections
t
. (See Fig.18.)
(2) Release the claw
u
of the thrust spring in the direction of
the arrow and remove the thrust spring. (See Fig.18.)
(3) Remove the screw shaft from the section
v
and remove it
in the direction of the arrow. (See Fig.19.)
(4) Remove the middle gear. (See Fig.19.)
(5) Remove the screw
L
attaching the feed motor to the C.TM
chassis. (See Fig.19.)
(6) Remove the wires from the soldered sections
w
on the
spindle motor board. (See Fig.19.)
(7) Take out the feed motor from the motor base.
Reference:
After attaching the feed motor, pass the wires through the sec-
tions
x
on the C.TM chassis as before. (See Fig.19.)
Fig.18
Fig.19
Thrust spring
Thrust spring
K
t
u
Feed bracket
Spindle motor board
Screw shaft
Middle gear
C.TM chassis
v
x
w
L
Summary of Contents for UX-G70A
Page 30: ...1 30 No MB551 Fig 36 Fig 37 Main tray Sub tray Tray stopper Tray stopper ...
Page 53: ... M E M O ...
Page 73: ...3 19 MEMO ...
