JVC Super LoLux TK-C9510E, Instructions Manual

Page: 19 / 324

Connection Settings
m
Control Signal Cable Connection on Camera (Rear)
Memo
Connect the cables correctly such
that the
A
,
B
,
C
,
D
marks of the
camera terminals coincide with those
of the RM-P2580 terminals.
m
Rear Switch Settings (
A
page 26)
Set the [RX TERM OFF
l
ON] switch.
Set only the camera connected by the control signal line to “ON”. Set to
“OFF” for all other cameras.
m
Menu Screen Settings (
A
page 34)
①
Select the [MAINTENANCE] item on the [MENU] screen, and
press the [SET] button.
The [MAINTENANCE] screen appears.
②
Move the cross key up/down to select the [COMMUNICATION]
item, move the cross key to the left/right to set to “JCCP”,
followed by pressing the [SET] button.
The [COMMUNICATION (JCCP)] screen appears.
③
Set [PROTOCOL 1] to “MULTIDROP”.
④
Set [PROTOCOL 2] to “DUPLEX”.
⑤
Set the [MACHINE ID] item according to the number of the
RM-P2580[VIDEO INPUT] terminal on each camera.
⑥
Press the [MENU] button to exit setting.
⑦
Turn off and on the power.
Memo
v
Turn off the power of the device to be used.
v
Refer also to the instruction manual of the device to be
used.
v
For details on the type of connection cable and distance,
refer to "Power Supply Connection" (
A
page 22).
v
Control signal cables do not support loop connection.
CAMERA
1
TO CAMERA DATA I / O RX+ RX- TX+ TX- COM 1 2 3 4 5 6 7 8 COM 9/1 10/2 11/3 12/4 13/5 14/6 15/7 16/8 COM COM COM CAMERA
SW UNIT
ALARM AUTO
4 3 1 2 8 7 5 6
2 3 4 5 6 7 8
1
MONITOR
OUTPUT MONITOR
SERIAL-2 SERIAL-1
VIDEO INPUT
VIDEO OUTPUT
OUTPUT
2
1 ON 2 3 4 5 6 7 8
RM-P2580
RX -
RX
+
TX -
TX
+
A B C D
RX -
RX
+
TX -
TX
+
A B C D
Connection/Installation
E-19