Masterpage:Right+
EN
63
Filename [DVM700EU_12Subsidiary.fm]
SUBSIDIARY SETTINGS
Page 63Wednesday, 25 January 2006 10:28
If you connect the unit and TV with Component Video Connection
(
A
pg. 16), you can select the scan mode from two modes:
Interlaced scan mode which is used in the conventional TV
system, and Progressive scan mode which enables reproduction of
higher-quality images.
8
Interlaced scan
In the conventional video system, a picture is shown on the display
monitor in two halves. The Interlaced scan system places lines of
the second half of the picture in-between lines of the first half of the
picture.
8
Progressive scan
Progressive scan displays all the horizontal lines of a picture at one
time, as a single frame. This system can convert the interlaced
video from DVD into progressive format for connection to a
progressive display. It dramatically increases the vertical
resolution.
1
Press
HDD
or
DVD
so that the HDD or DVD lamp lights up on
the unit.
2
Press
PROGRESSIVE SCAN
for 3 or more seconds.
●
Video output indicator (
q
) lights on the front display panel if
Progressive scan mode has been established. (
A
pg. 12)
●
Each press of
PROGRESSIVE SCAN
for 3 or more seconds
switches the scan mode.
NOTES:
●
Interlaced scan mode is the setting at your purchase.
●
Interlaced scan mode might be suitable depending on video
material.
●
Scan mode cannot be set while menu screen is displayed.
●
When the Progressive scan mode is engaged, no video signal is
output from [S-VIDEO OUTPUT] connector and [VIDEO/AUDIO
OUTPUT] connectors.
You can lock the disc tray to prohibit the unwanted disc ejection by
children.
To lock tray
While the unit is turned off, press and hold
o
, then press
M
on the
unit.
A
LOCK
B
appears on the front display panel and the disc tray
is locked.
To unlock tray
While the unit is turned off, press and hold
o
, then press
M
on the
unit.
A
UNLOCK
B
appears on the front display panel.
During playback or recording, press and hold
F1
for more than 5
seconds.
A
LOCK
B
appears on the front display panel.
●
No buttons will function and playback and recording will not be
interrupted.
●
When the unit is in the stop mode, all buttons will not function
except
R
and
I
.
To cancel Mode Lock, press and hold
F1
again for more than 5
seconds.
NOTE:
It is also possible to use Mode Lock during Repeat Playback
(
A
pg. 25).
When the power plug is disconnected from unit or when power
failure occurs, your settings for the following functions are kept in
the memory. These settings will resume when the unit is turned on
again.
●
Input selection (channel or auxiliary input; L-1, F-1 or DV)
●
Recorder selection (The last selected deck is memorised.)
●
Recording speed (
A
pg. 48)
●
Mode settings (
A
pg. 57 – 59)
Scan Mode Set (HDD & DVD Deck Only)
ATTENTION:
Your TV needs to be compatible with PAL Progressive.
●
Turn on the unit.
●
Turn on the TV and select the AV mode.
●
Slide the
TV/DVD
switch to
DVD
.
PROGRESSIVE SCAN
DVD
HDD
DVD
TV
Tray Lock (DVD Deck Only)
●
Turn off the unit.
Mode Lock
Last Function Memory
o
M
DVM700EU_00.book Page 63 Wednesday, January 25, 2006 10:28 AM
