Masterpage:Right0
EN
33
Filename [DVM600US_08DV Operation.fm]
Page 33Monday, 25 September 2006 13:54
BASIC OPERATIONS ON DV DECK
1
Load a cassette. Make sure the window side is up, the rear
label side is facing you and the arrow on the front of the
cassette is pointed toward the unit.
●
Do not apply too much pressure when inserting.
●
If the erase protection switch is set to
A
SAVE
B
, playback begins
automatically. It takes about 15 seconds until the playback
picture appears.
●
The unit’s power comes on automatically.
2
Press
DV/HDD/DVD
on the unit repeatedly or
DV
on the remote
control so that the DV lamp lights up on the unit.
3
Find the program start point. If the tape is advanced past the
start point, press
O
. To go forward, press
N
.
4
Press
I
to start playback.
5
Press
o
to stop playback.
●
To eject the cassette, press
M
(DV). You can also eject the
cassette when the unit is turned off.
NOTES:
●
When you record a tape on the DV deck with the recording speed
set to
A
LP
B
, it is recommended to play back that tape back on this
DV deck. Digital video recorder from other manufacturers may not
be able to play back the tape properly.
●
It is possible to play back on the DV deck and the HDD/DVD deck
simultaneously. However, either DVD or HDD can be played at
the same time.
Basic Playback
●
Turn on the unit.
●
Turn on the TV and select the AV mode.
●
Slide the
TV/DVD
switch to
DVD
.
DV/HDD/DVD
I
M
o O N
DV
o
N
O
I
DVD
TV
DV lamp
Clean the video heads using a dry cleaning cassette
- M-DV12CL - when:
●
No picture during playback.
●
Block noise appears during playback.
●
A
USE CLEANING CASSETTE
B
appears on the screen.
●
A
U01
B
lights on the front display panel.
NOTES:
●
The heads get dirty in the following cases:
●
in an environment prone to extreme temperature or humidity
●
in a dusty environment
●
flaw, dirt or mould on video tapes
●
continuous usage for a long time
●
A
U01
B
will also light on the front display panel when you
attempt to play back a tape recorded with PAL signals. This unit
cannot play back tapes recorded with PAL signals.
Usable cassettes
●
Cassettes marked
P
can be used with the DV deck.
●
Tapes recorded in the DVCAM format can be played.
Accidental erasure prevention
To prevent accidental recording on a recorded cassette, set its
erase protection switch to
A
SAVE
B
. To record on it later, set the
switch to
A
REC
B
.
Erase protection switch
DVM600US_00.book Page 33 Monday, September 25, 2006 1:54 PM
