Operating Your Remote Control
2
Installing the Base Stand
3
The screw holes will only align if the
front of the TV stand is at the front
of the TV.
Install the batteries correctly by following the polarity (+ and -) indications
in the battery compartment.
Quick Start Guide
39” LED HD TV
LT-39C460
Unpacking
1
Remove all packaging from the TV. Retain the packaging. If you
dispose of it please do so according to any local regulations.
1. Press and lift the back cover to open the battery compartment of
the remote control.
Thank you
for purchasing your new JVC TV.
Your new TV incorporates the latest technology to enhance your viewing
experience. We would suggest that you allow about 20 mins for initial setup.
Please follow this guide for a successful first time installation.
For Help and Support Call
UK: 0344 561 1234
Ireland: 1890 818 575
Screw x 3
Screw x 3
The latest eco-friendly power-saving technology will switch off the TV if device is
left on and idle for 4 hours. Please refer to “Auto Standby” under the “Time Settings”
section of the instruction manual for more detail.
Connecting the Aerial and the Mains Socket
4
1. Lay the TV down on a flat surface with the back side facing up, and ideally at the edge of a table so that the base of the TV slightly overhangs on it. Please
make sure a soft cushioned material (such as a pillow or thick piece of foam) is placed beneath the screen.
2. Attach the TV stand to the TV. Align the screw holes, then secure with a screw driver (not included) using the screws provided.
1. Connect one end of the RF coaxial cable to the aerial socket on the wall and the other end of the cable to the RF (75Ω) socket at the rear right bottom of
your TV.
2. Unwind the mains cable to its full length. Connect the mains cable to the mains socket after you have completed all the connections.
3. At this stage, the TV switches to standby mode. The red LED indicator will illuminate on the front panel of the TV.
4. In standby mode, press the button on the left bottom panel under the TV frame or on the remote control to turn the TV on. The red LED indicator will
turn blue.
• Do not connect the TV to the mains supply until you have completed all the connections.
• If you watch TV using a set-top box, simply connect your TV and set-top box via a HDMI cable and select HDMI in the Input Source menu.
1
2
HDMI3
USB
RF
COMMON INTERFACE (CI)
AV
YPbPr
Digital Audio Output
(Optical)
RF coaxial cable
(not included)
OR
To the mains socket
2. Insert two AAA size batteries. Close the battery compartment
cover.
Instruction Manual
Quick Start Guide
TV Stand (Left) x 1
TV Stand (Right) x 1
Remote Control /
AAA Batteries x 2
2
1
3
4
6
5
7
8
9
0
OK
MENU
INPUT
BACK
PROG
INDEX
HOLD
SIZE
REVEAL
FAV
MENU
ANGLE
TITLE
SLOW
ZOOM
TEXT
CANCEL
TV.RD
MIX
S.PAGE
STEP
GOTO
A-B
EXIT
DVD SETUP
GUIDE
ASPECT
LIST
S
AUDIO
REPEAT
VOL
CH
TV
Screw (BM4x8mm)
x 6
Component
Adapter Cable
Composite
Adapter Cable
