5
3
2
Insert the batteries into the handset
Connect the
Aerial/Cable straight
to your TV
Connect the TV to the mains socket
HDMI input
6
Start Auto Setup procedure
PLEASE ENSURE BOTH UNITS ARE SWITCHED
OFF BEFORE CONNECTING. Use a HDMI to HDMI
cable to connect the two units together. To select the
HDMI input, press the
SOURCE “
button on the
remote control. Each time it is pressed, the on-screen
menu confirms your selection.
”
To HDMI connection on
the device
1
Quick Start Guide
Aerial or Cable
insert plug...
50242108
CH
/ CH
Slide the back cover up to open the battery
compartment of the remote control. Observe the
correct polarity (+/-) when inserting batteries.
Replace the cover.
5
4
HDMI input
To switch the TV on
Connect the power cord to the 220-240V AC, 50 Hz.
To switch on the TV from standby mode either:
Press the "
" button,
P+ / P-
or a numeric
button on the remote control.
Press the side function switch until the TV comes
on from standby.
1.
2.
IMPORTANT: Ensure that the
aerial/cable
is
connected
and a Common Interface module is not
inserted before switching on the TV for the first
time installation. Do not insert a common interface
module during the search process.
When turned on for the first time, the language
selection screen is displayed. Select the desired
language and press OK.
First Time Installation (FTI) screen will be displayed
next. Set your preferences using the navigation
buttons and when finished, press OK to continue.
If Home Mode is selected, Store mode will be disabled
after the First Time Installation. Press OK button to
continue and select Yes to proceed.
You can activate Store mode option to be available in
"Other settings" menu and your TV's features will be
illustrated on the top of the screen. A confirmation
screen will be displayed. Select
YES
to proceed.
Cable Installation
Select
CABLE
option and press
OK
button on the
remote control. To continue, you can select frequency
ranges from this screen.
Enter the frequency range manually by using the
numeric and press OK to start the search.
Note:
Searching duration will change depending on
the selected search step.
Aerial Installation
If you select
AERIAL
option from the Search Type
screen, the television will search for digital terrestrial
TV broadcasts.
NOTE:
You can press
MENU
button to cancel.
After all the available stations are stored, the Channel
List will be displayed on the screen. If you would like
the channels to be sorted according to LCN(*), please
select YES and press OK.
Press
MENU
button to quit channel list and watch
TV.
(*) LCN
is the Logical Channel Number system that
organizes available broadcasts in accordance with a
recognizable channel sequence (if available).
Downloaded from www.vandenborre.be
