JVC LST0728-001C, Instructions Manual

Page: 147 / 168

139
You can record images before and after the occurrence of an event
or motion when recording in the recording control mode
(
A Page 53).
1
Go to [Settings] ( A Page 56), and select
A Conditionally B in [Recording Settings] - [When
to store images in database]
2
Select A On motion B or A On event B
3
Specify the number of seconds in [( )seconds
pre/post recordings on motion/event]
●
Images are recorded during the specified time interval
before and after an alarm or motion is detected.
Memo :
●
Sequences refers to sequences of images that are recorded
when an event or motion is detected.
●
For details on using sequences, refer to [Searching Recorded
Image Using Sequence] ( A Page 44).
Connecting the PTZ camera to the COM port of the network
encoder (VN-E4) enables the PTZ control on the live screen of the
NVR Viewer. For details on PTZ camera settings, refer to [PTZ
Camera Settings (COM1/COM2)] (
A Page 88).
For cameras that have specified the [JCBP-S] protocol in A P/T/Z
type controlled through COM1/COM2 B of [PTZ Camera Settings
(COM1/COM2)], control of the iris, focus and camera menu are also
enabled on the live screen of the NVR Viewer in addition to PTZ
control.
Memo :
●
A PTZ camera is an analog camera with an analog output that
enables PTZ control via RS-485.
1
Press and hold the [FUNCTION] button, and
press the [5] keypad button at the same time
●
The [Camera Control] screen appears.
2
Select the camera you want to control from the
camera selection list, and click the
[Connect(ENTER)] button
●
Camera control is enabled.
●
The functions of the buttons are described below.
Recording Before/After
Occurrence of Event or
Motion
Stopped Stopped
Motion or event
Records for set time before Records for set time after
Set time Set time
1
2
3
PTZ Camera Control
OPERATE
REC CONTROL
LIVE/BROWSE
SELECT
PTZ/PRESET
SERIAL
㧝 㧞 㧟 㧠
㧡
㧢*1/'
㧣
㧥
㧤
CANCEL ZOOM OUT ZOOM IN ENTER
WARNING
ALARM
HDD
LOCK
SEARCH FUNCTION ALARM CLEAR KEY REC/STOP STOP(PB) PLAY
SKIP
REV FWD
[5] Button
[FUNCTION] Button
2
[NVR]