JVC LST0728-001C, Instructions Manual

Page: 115 / 168

107
E-mail Settings
Memo :
●
You can send a test e-mail by clicking the [Test] button. If the e-
mail address of the sender is not registered with the mail server
of the recipient, the [The mail address of the sender is not valid.
...] message may appear. When this occurs, double-check the
sender’s e-mail address and outgoing mail server, and re-enter
the e-mail address.
●
E-mail messages are sent in the following cases.
●
When an input event occurs
( A Page 96 [Specifying an Input Event])
●
When the event button is clicked
( A Page 99 [Configuring Event Buttons])
●
When a generic event occurs
( A Page 100 [Specifying Generic Events])
●
When motion is detected
( A Page 105 [Specifying Motion Detection])
●
When camera failure occurs
●
When an archiving error occurs
(
A
Page 108 [Archiving])
●
In order to send an e-mail via Motion Detection, you need to
specify the timing for sending out e-mails in [Scheduler Setting]
(
A Page 53).
●
After you have completed the e-mail setting, perform a test to
verify that it can be sent successfully.
A
B
C
D
E
G
F
[E-mal setup] Screen
Item Description
A
Enable E-
mail(Monitor) Select this check box to enable sending of
e-mail alerts.
B
Recipient(S) For specifying the e-mail addresses to
send alerts to. If you are specifying more
than one e-mail address, separate the e-
mail addresses using semicolons.
C
Sender
Settings For specifying the sender’s e-mail address,
outgoing (SMTP) mail server name and
login settings.
D
Subject text For specifying the mail title.
E
Message text For specifying the message text.
F
Time
btw.mail(min
utes) For specifying the time interval (minutes)
for sending each e-mail alert.
G
Include
Image Select this check box to include images in
the message.