94
Applications
Auto PTZ Patrolling (continued)
䡵
Specifying Patrol Timing
1
Select the patrol scheme that you want to define
from the [Patrol scheme] list
2
Specify the duration (seconds) for the PTZ
camera to stop at each preset position in the
[Stay at each position in the patrol schedule(in
seconds)] field
3
Specify the time required for the PTZ camera to
move between two preset positions in the [Time
for each PTZ camera movement to complete(in
seconds). Motion detection is disabled during
movement.] field
Memo :
●
In order not to generate false motion alarms, motion detection
and recording are automatically disabled when the PTZ camera
is moving between two preset positions. After the lapse of the
specified interval, motion detection is automatically enabled
again.
Note :
●
It is important that the camera is able to reach all the preset
positions defined in the patrolling scheme within the time interval
you have specified. Otherwise, false motion may be detected.
䡵
PTZ Patrolling Actions Upon Detection of Motion
1
Select the [Disable patrolling schedule if motion
is detected] check box
2
Select the conditions for resuming PTZ
patrolling
●
When a specific time interval has lapsed after the first
detected motion, regardless of whether any subsequent
motion is detected
●
When a specific time interval has lapsed after the last
detected motion
3
Specify the selected condition in units of
seconds
䡵
PTZ Scanning
For cameras that support PTZ scanning, you can enable this
feature in the [Setup of PTZ Scanning] section to select a PTZ
scanning speed.
Note :
●
To define a patrol scheme, you must specify at least two preset
positions. You must also specify the period for which the patrol
scheme is enabled in [Camera Record Setting]
-
[Scheduler...].
●
Patrolling of PTZ cameras may be interrupted either manually or
when an event occurs. When this occurs, you need to specify the
duration (seconds) before resuming patrol in [Camera Record
Setting]
-
[General Settings]
-
[Patrolling Settings]. The settings in
this section are applied to all PTZ cameras installed in the
system. The default setting is 30 seconds.
Defining a Preset PTZ
Position (continued)
[Setup PTZ Patrolling] Screen
Summary of Contents for LST0728-001C
