JVC LST0728-001B, Instructions Manual

Page: 158 / 162

150
Others
Default Value List
(continued)
User Administration (Distribution Settings
A
Page 118)
VR-N1600U/E
User Password Type
vr-n1600 [vr-n1600] Basic user
Administrator [None] [Windows or Active Directory user]
VR-N900U
User Password Type
vr-n900 [vr-n900] Basic user
Administrator [None] [Windows or Active Directory user]
HDD Utility (Advanced Settings
A
Page 116)
NAS User Settings
Password [None]
User name [None]
Auto Archive
Enable archiving to internal HDD [Selected]
Troubleshooting
Symptom Action
Power cannot be turned on. Check to ensure that the power cable has been plugged in correctly.
Check to ensure that the power switch on the rear panel is switched on.
Camera is not automatically detected. Follow instructions in the camera’s [Instruction Manual] to check the IP address
settings.
When the IP Lease feature is in use, turn OFF the camera and ON again with this unit
started up.
Unable to control using [REC] and [PLAY]. Check to ensure that the operation lock is not turned on.
Images are not recorded in the recording control
mode. Check the [Camera Recording Settings].
Check to ensure that the scheduler is set to online.
Check to ensure that the camera is in the recording control mode.
Unable to play back audio sound. Check to ensure that the audio item of the camera device is set to
A
Enabled
B
in the
[Camera Record Setting] menu.
Check to ensure that audio is selected in [Audio].
Operation of the unit is disabled. Press and hold the [FUNCTION] button on the front panel, and press the [OPERATE]
button for 7 seconds or longer to shut down the power forcibly.
Memo :
●
When the power is forcibly shut down, recorded images that are not archived
(
A
Page 108) may not be properly played back.
The message below appears after turning on the
power.
A
COMS Settings Wrong CMOS Date/ Time Not Press
F1 to Run SETUP Press F2 to load default values
and continue
B
The built-in backup battery level is running low.
Consult your nearest JVC service center.